Heat Pump Maintenance in Piqua, Sidney, Troy, OH, and Surrounding Areas
Burkett's Heating & Cooling
Whether you’re looking to install a new heat pump or already relying on one in your home, it’s essential to understand how to maintain it to continue providing reliable heating and cooling throughout the long winters and summers. Here are some of the most important things to remember when heat pump maintenance. Contact Us Today for Heat Pump Maintenance in Piqua, Sidney, Troy, OH, and Surrounding Areas.
Eight Ways To Maintain Your Heat Pump:
- Check the thermostat
Suppose your thermostat has been set at a higher temperature than usual. In that case, you may notice that your heat pump often runs for extended periods of time. This can indicate that your thermostat is not set correctly and should be adjusted as soon as possible. Additionally, check that it is on a programmable schedule.
- Check the condenser coil
The condenser coil is one of your heat pump’s most essential components. That’s because it transfers heat from inside your home to outside. However, debris, dust, and dirt can build up on it over time and prevent proper airflow, leading to reduced efficiency.
- Flush the drain line
Try flushing out your drain line by manually opening a tap inside or near an indoor faucet. You can also use an electric heater or dehumidifier indoors as long as you are there to monitor it. If no one is home, turn up the temperature setting on the heat pump and open some windows.
- Clean and lubricate air filters
Regularly cleaning and lubricating your air filters is essential in heat pump maintenance. Some heat pumps have permanently-attached disposable filters, while others allow you to remove and clean or replace your filter as needed. Check and change out your filters every three months to ensure your system runs at its peak efficiency.
- Clean the fan blade
First, make sure that you have unplugged your heat pump fan. Then, loosen or remove any hoses connected to your fan blade to ensure they do not get caught while you clean it. Next, clean dirt and debris between your blades using a cleaning brush and wipe away dust with a soft cloth or paper towel.
- Clean the outdoor coil
Before operating your heat pump, clean off any debris on your outdoor condenser coils. It helps ensure the optimal performance and efficiency of your heat pump. Do not get water directly on any electrical components, as doing so could cause a short circuit.
- Change the humidifier filter
This step is essential because your entire system can suffer if you don’t change your filter after every cooling season. That’s why ensuring you keep up with cleaning and maintaining your heat pump is vital.
- Change the system
Turn your thermostat up to 90 degrees, unplug your heat pump and then plug it back in. Check your home every 30 minutes and write how hot or cold it is inside. In 6 hours, you should have determined what should be changed with your thermostat and need to charge it to work appropriately.